EVO Surface Wall Mount Installation Instructions
PM0437-02
EVO SURFACE WALL MOUNT INSTALLATION INSTRUCTIONS
PAGE 1 OF 2
EVO Surface Wall Mounting
CONTENTS:
QTY PART
#
DESCRIPTION
1 MW0804-01
BOTTOM
TOWER
COVER
4
HW4559-03
1/4 – 20 x. 50L PAN HEAD PHILLIPS MACHINE SCREW
NOTE: THIS INSTALLATION SHOULD ONLY BE PERFORMED BY A QUALIFIED SERVICE TECHNICIAN.
To mount the EVO on a wall follow the instructions below.
NOTE: If you are mounting the EVO on the wall, the wall must not be a structural, or
load-bearing wall.
EVO with Coin: If you are installing the EVO on the wall, a quick adjustment to the coin mech is
required for proper operation of the mech. Follow the instructions below to adjust the coin mech
before continuing with the installation instructions. For EVOs with bill acceptors only, continue
with the installation instructions on the reverse side of this sheet.
1. Unlock and open the cash tower.
2. Using Figure 1 as a guide, pull the bottom tabs on the coin mech out of the back notch on the coin
mech bracket and place the bottom tabs on the coin mech in the front notch on the bracket. The top
tabs should remain in the back notch.
3. Close and lock the cash tower and continue with Surface Wall Mount Installation Instructions on the
reverse side of this sheet.
NOTE: If you change the mounting of the EVO to table or bar top mounting, you must return the
coin mech to its original position.
FIGURE 1 - PROFILE OF COIN MECH BRACKET
BAR
MOUNT
WALL
MOUNT
EVO Surface Wall Mount Installation Instructions
PM0437-02
EVO SURFACE WALL MOUNT INSTALLATION INSTRUCTIONS
PAGE 2 OF 2
Surface Wall Installation Instructions
1. Carefully lay the game on the monitor side. If the lazy Susan on the bottom of the game has a single
screw in the middle, remove the screw and remove the lazy Susan. Then, remove the base from the
EVO by removing the 4 screws securing the base to the game.
If your lazy Susan does not have the screw in the middle, pull off the adhesive pad and use the large
access hole in the bottom of the lazy Susan to gain access to the four screws securing it to the game.
Remove the screws and remove the lazy Susan. Then, remove the base from the EVO by removing
the 4 screws securing the base to the game.
2. Attach the provided bottom plate to the cash tower using the 4 supplied screws as shown in Figure 2.
3. Unlock and open the cash tower on the EVO. See Figure 2. If you have a coin EVO, remove the
coin box to gain access to the mounting holes in the back of the tower.
4. Using the mounting holes in the cash tower as a guide, drill the 4 holes needed to mount the game on
the mounting surface.
5. Secure the EVO to the wall with sufficient hardware to support the weight of the game (75 pounds for
EVOs with bill acceptors only and 85 pounds for EVOs with coin). See Figure 2.
6. If you have a coin EVO, replace the coin box.
7. Close and lock the cash tower.
MOUNTING
SURFACE
SCREWS SECURING
BOTTOM PLATE ON
CASH TOWER
(4 PLACES)
CASH TOWER
ON EVO
ANCHORED
FASTENER
(4 REQUIRED)
FIGURE 2 – EVO CASH TOWER – SURFACE WALL MOUNTING